1. YOU CAN CONNECT THESE 5 ON-LINE DEVICES TO ONE COMPUTER OR SPREAD THEM OUT ACROSS TWO OR THREE COMPUTERS.

2. IF YOUR COMPUTER DOES NOT HAVE A GAMEPORT OR SOUNDBOARD (THAT SUPPORTS (2) JOYSTICKS) . INSTALLED, THEN YOU MUST INSTALL A GAME CARD IN EACH COMPUTER THAT WILL ACCESS THE ON-LINE DEVICES.

3. CONNECT THE JOYSTICK CABLE TO THE CONNECTION MARKED “JOYSTICK” ON THE FOOTPEDAL CABLE.  PLEASE MAKE SURE THAT THE SWITCH ON THE FRONT OF THE FOOTPEDALS IS SET TO PLANE NOT CAR.

4. GO TO STEP 10 ON COMPUTERS THAT WILL ONLY HOLD A JOYSTICK AND FOOTPEDAL.

5. CONNECT THE SPECIAL ON-LINE CABLE CONNECTOR MARKED “’B’ GAME PORT CMPTR” TO PORT ‘A’ ON THE GAME CARD.

6. CONNECT THE SPECIAL ON-LINE CABLE CONNECTOR MARKED “’A’ SERIAL PORT” TO A FREE SERIAL PORT ON YOUR COMPUTER.

7. CONNECT EITHER THE FINGER OR THE MANUAL DEXTERITY UNITS TO THE CONNECTOR MARKED “’C’ TEST UNIT” ON THE SPECIAL ON-LINE CABLE.

8. IF YOU ARE GOING TO USE THE JOYSICK AND FOOTPEDALS ON THE SAME COMPUTER AS THE FINGER OR MANUAL DEXTERITY UNITS THEN DO STEP 9, OTHERWISE DO STEP 10.

9. CONNECT THE SPECIAL ON-LINE CABLE CONNECTOR MARKED “’D’ GAME PORT CABLE” TO THE CONNECTOR MARKED “GAMEPORT” ON THE FOOTPEDALS.

10. CONNECT THE FOOTPEDALS CONNECTOR MARKED “GAMEPORT” DIRECTLY TO PORT ‘A’ ON THE GAME CARD.

11. IF YOU ARE USING A WIN32 OPERATING SYSTEM LIKE WINDOWS 95 OR WINDOWS NT, YOU WILL NEED TO CALIBRATE THE JOYSTICK AND FOOTPEDALS.  PLEASE FOLLOW THE STEPS SHOWN ON YOUR “ADDING A GAME PORT DRIVER FOR WINDOW” INSTRUCTION PAGE.

12. THE ON LINE TESTING  PROGRAM LOOKS FOR THE MANUAL AND FINGER DEXTERITY UNITS ON A COMPORT DEFINED BY THE ENVIRONMENT VARIABLE CALLED “MF_COM”.  BY DEFAULT THE COMMPORT IS SET TO COM2.  IF YOU INSTALLED THE CONNECTOR MARKED “’A’ SERIAL PORT” ON ANOTHER COMMPORT, THEN YOU WILL NEED TO CHANGE MF_COM APPROPRIATELY.

IT IS SET TO,MF_COM=COM2...EXAMPLE: CHANGE THE SETTING TO MF_COM=COM3 FOR COM3